spray paint viscosity test seconds latex

Every 10-15 seconds, remove the paint shaker and watch the diluted paint drip from the shaker. Now, use your paint shaker to make sure the paint and water are well mixed. Remember, it is better to add a little water at a time and add more later than to add more paint because you have spilled too much water initially. It is better to pour the water in small increments than all at once.Īlso, be sure to mix the water with the paint with your opposite hand as you pour it into the bucket. Make sure the water is at room temperature. The general rule of thumb for thinning the paint with water is to use 1/2 cup of water for every gallon of paint. Now is the time to add water to the paint to thin it out. Let it hang over the bucket for a few seconds until the drip slows significantly. Next, use your paint shaker to scrape off any paint on the inside of the can. Most latex paints will drip in one long stream, then drip smaller until the dripping finally stops. This is known as checking the viscosity of the paint. When removing the paint stirrer, watch the paint on the stick to see how it drips. You can also agitate the paint by holding it with both hands and tilting it from side to side for about 30 to 60 seconds.

Check the current thickness level of your paintįirst, use your paint shaker to mix it for about 30 to 60 seconds. Let’s take a look at the complete process. The paint thinning process is quite simple, you can easily use water to thin the paint. Read our full guide about HVLP VS Airless Paint Sprayer. Latex paint is quite thick, so thinning latex paint is a must-do when using a handheld spray gun, HVLP sprayers, or airless paint sprayers. Latex or nitrile gloves How to Thin Latex Paint for Sprayer.To do any job properly, you must have the right tools to get the job done.

If you have this type of paint sprayer, the manufacturer’s instructions and user manual will detail how you should test your paint to make sure it is the proper thickness for the paint sprayer you have.įor most paint sprayers, you can determine if the paint will pass through the paint sprayer properly by pouring it into a common household funnel with a small spout. Most of these sprayers don’t even require the latex paint to be thinned. Some paint guns are highly developed and can pump paint directly from the bucket that the paint comes in. Check the current thickness level of your paint.

Spray paint viscosity test seconds latex